Chase Speed slider shows 0.10s after reboot#390

Description
In Playback Mode “Chase”, the Chase Speed value is saved and applied correctly.
After rebooting the console, the Chase Speed slider is shown as 0.10s even if a different value was set before the reboot.

This appears to be a UI/visual issue only.

Initial conditions

• Playback Mode: Chase
• Chase Trigger: Local Speed / Tap Sync
• Chase Speed slider: any value greater than 0.10s

Steps to reproduce

1. Set the Chase Speed to any value greater than 0.10s.
2. Start the Chase and confirm it runs at the selected speed.
3. Stop the Chase.
4. Reboot the console.
5. Open the Chase page again and check the Chase Speed slider value.
6. Start the Chase and verify the actual speed.

Expected result
After reboot, the Chase Speed slider should show the previously set value.

Actual result
After reboot, the Chase Speed slider is shown as 0.10s, but the Chase runs at the previously set speed.

Notes

• Touching/moving the slider updates the displayed value correctly.
• The speed value seems to be stored and restored correctly; only the initial slider display appears incorrect.

Thanks for the detailed bug report!

We’ll have a look